IsoCoat Tank Lining PW is a 100% solids; state-of-the-art; VOC-free; plural-component; pure polyurea elastomeric membrane. This seamless system exhibits extraordinary performance characteristics. This inherently sound dampening coating can be applied to be non-slippery. This membrane achieves an extremely tough; flexible; chemical and abuse resistant finish for a wide range of applications. IsoCoat Tank Lining PW meets the requirements of NSF/ANSI/CAN 62 – 2018 for a nominal pipe diameter of 18 inches.
File Downloads
Technical Data SheetApplications
- Aquariums
- Cold storage areas
- Concrete or earthen containment areas
- Cooling tower liners
- Fertilizer plants
- Petrochemical plants
- Pipe coatings (interior/exterior)
- Pulp and paper mills
- Tank Linings
- Waste water tanks and facilities
Advantages
- Application at 20F to 300 F
- Can be top coated for UV or chemical resistance
- Fast cure; can be handled/walked on in minutes
- Fungus resistant
- Higher Elongation & Greater Flexibility
- Resistant to many chemicals
- Resistant to thermal shock
- Seamless & can be applied at any thickness
- Slower reactivity & better substrate wetting
- Smooth Finish
- USDA Approved
Product Types
Coating
Product Testing
| Test Performed | Test Results |
| % Solids - by Volume | 100 |
| % Solids - by Weight | 100 |
| Chip Resistance - SAE J400 | 10 |
| Color - ISO | Light Yellow |
| Color - POL | Gray |
| Elongation - ASTM D412 | 450 % |
| Flame Spread - ASTM E108 | Class A |
| Flame Spread - FMVSS 302 | Pass |
| Full Cure | 24 Hours |
| Hardness - ASTM D2240 - Shore A | 95 Shore A |
| Hardness - ASTM D2240 - Shore D | 50 Shore D |
| Mandrel Bend - ASTM D522 - 1/4" Mandrel-20 C, 30-50mil Free Film | Pass |
| Mandrel Bend - ASTM D522 - Conical Bend 1/32" Steel panel | Pass |
| Ratio by Volume - ISO:POL | 1-1 |
| Ratio by Weight - ISO:POL | 1.1-1 |
| Return to Service - Foot Traffic | 1 Hour |
| Sprayed Gel Time | 5 Seconds |
| Taber Abrasion Resistance - ASTM D4060 - 1000g, 1000rev, H 15 | 10 mg |
| Taber Abrasion Resistance - ASTM D4060 - 1000rev, CS 17 | 220 mg |
| Tack Free Time | 8-20 Seconds |
| Tear Strength - ASTM D624, Die C | 495 pli |
| Tensile Strength - ASTM D412 | 3000 psi |